HYDROSTATION
Hydrostation is the new IE5 efficiency class electronic system for constant pressure…
AISI 304 stainless steel submersible pump with mechanical seal in oil bath and oversized oil chamber. Possibility of fixed or mobile installation and suitable for domestic applications and large industrial drainage installations. Read more
Flow rate | from 1.2 to 9 m³/h |
Total head | from 1.5 to 7.6 m |
Max. temperature of the liquid | +50°C |
Poles | 2 |
Max. solids passage | 10 mm |
Insulation class | F |
Protection degree | IP68 |
Voltage | Single phase 1 ~ 230V ± 10% |
Max. immersion | 5 m with 10 m cable 2 m with 5 m cable |
Pump body | Stainless steel AISI 304 (EN 1.4301) |
Impeller | PPE + PS reinforced with glass fibres |
Shaft | Stainless steel AISI 303 (EN 1.4305) (part in contact with liquid) |
Mechanical seal | Ceramic/Carbon/NBR (mechanical seal) QQV Silicon Carbide/FPM (special mechanical seal) NBR (lip seal) |
How can I adjust the float switch in order to avoid problems when starting or stopping?
If the pump is fitted with a float switch, the latter must have enough room to move freely, so that it can switch and ensure a proper pump operation.
Please follow the directions provided in the instruction manual when the installation requires float switches that are fixed to the tank and are driven by a distribution board.
What should the dimensions of the handhole where I’m inserting the pump be?
It depends on the pump’s type and model.
Strictly follow the directions provided in the instruction manual.
Can I extend/replace the power cord without causing technical problems or affecting the warranty?
Yes, anyhow this operation has to be carried out by a specialised technician or at an authorised EBARA Service Centre. This avoids improper connections that can adversely affect the pump’s correct operation and/or the safety of the installation.
What is the minimum amount of liquid that the pump must be submerged in?
Strictly follow the directions provided in the instruction manual.
Contact us
* Required