HYDROSTATION
Hydrostation is the new IE5 efficiency class electronic system for constant pressure…
5" submerged pump with stainless steel outer casing and glass fibre reinforced PPE impellers, built with double mechanical seal in oil chamber. Equipped with 20 metres of cable, it is easy to install and suitable for vertical and horizontal operations. The single-phase version with float switch (called "A" version) is also available on request. Read more
Flow rate | from 1.2 to 7.2 m³/h |
Total head | from 10 m to 76 m |
Max. working pressure | 10 bar |
Max. temperature of the liquid | +40°C |
Poles | 2 |
Insulation class | F |
Protection degree | IP68 |
Voltage | Single-phase 1~230V ±10% Three-phase 3~230/400V ±10% |
Impeller | PPE+PS with glass fibres |
Shaft | Stainless steel AISI 431 (EN 1.4057) |
Mechanical seal | Carbon/Ceramic/NBR (motor side) Silicon Carbide/Carbon/NBR (pump side) |
Outer casing | Stainless steel AISI 304 (EN 1.4301) |
Should there be a oil leakage or the motor break inside the well, could the oil contaminate the water?
No, the oil that is used is food grade dielectric oil, therefore it’s been specifically developed so that it will not contaminate the water inside the well
I have a single-phase motor with a 4 wire output. How do I connect them?
The motor cable is standard for both single-phase as well as three-phase versions. For a single-phase motor, the brown wire has to be connected to the blue capacitor.
Can submersible pumps and motors operate submerging them in a tank?
Yes, it’s important to:
Can submersible pumps and motors operate in an horizontal position?
Yes, what matters is that the they are properly aligned and positioned with the hydraulics and therefore collars have to be used to secure the pump to the tank’s bottom, this assures stability and a correct position.
Contact us
* Required