HYDROSTATION
Hydrostation is the new IE5 efficiency class electronic system for constant pressure…
3” submerged well pump with outer casing in AISI 304 stainless steel and impellers in glass fibre reinforced PPO. Suitable for handling water in general and also for horizontal operation. Read more
Flow rate | from 0.6 to 2.7 m³/h |
Total head | from 9.8m 122 m |
Max. temperature of the liquid | +30°C |
Poles | 2 |
Insulation class | F |
Protection degree | IP58 |
Voltage | Single phase 1~230V ±6-10% Three phase 3~400V ±6-10% |
Max. immersion | 60 m |
Max. sand content | 50 ppm |
Impeller | PPO reinforced with glass fibres |
Shaft | Stainless steel AISI 430F (EN 1.4105) |
Outer casing | Stainless steel AISI 304 (EN 1.4301) |
Discharge casing | Stainless steel AISI 304 (EN 1.4301) |
Motor connection | Stainless steel AISI 304 (EN 1.4301) |
I have a single-phase motor with a 4 wire output. How do I connect them?
The motor cable is standard for both single-phase as well as three-phase versions. For a single-phase motor, the brown wire has to be connected to the blue capacitor.
Can submersible pumps and motors operate submerging them in a tank?
Yes, it’s important to:
Can submersible pumps and motors operate in an horizontal position?
Yes, what matters is that the they are properly aligned and positioned with the hydraulics and therefore collars have to be used to secure the pump to the tank’s bottom, this assures stability and a correct position.
Should there be a oil leakage or the motor break inside the well, could the oil contaminate the water?
No, the oil that is used is food grade dielectric oil, therefore it’s been specifically developed so that it will not contaminate the water inside the well
Contact us
* Required